Blue Star AC Error Codes: What Each Code Means and How to Fix It
Blue Star is one of India’s most trusted AC brands, especially popular in commercial and high-end residential applications. Its split ACs display error codes when a fault is detected. This guide explains every common Blue Star AC error code, the most likely cause, and the fix to try before calling a technician.
Blue Star AC Error Code Table
| Code | Meaning | Fix |
|---|---|---|
| E1 | Indoor temperature sensor fault | Check sensor connector; replace sensor if faulty |
| E2 | Indoor coil temperature sensor fault | Inspect sensor connector on PCB; replace if needed |
| E3 | Outdoor temperature sensor fault | Check outdoor unit sensor; replace sensor |
| E4 | High pressure protection | Clean condenser coil; ensure outdoor unit has clear airflow |
| E5 | Low pressure / refrigerant fault | Check for refrigerant leak; call technician |
| E6 | Communication error (indoor–outdoor) | Power cycle both units; check inter-unit wiring |
| E7 | Indoor fan motor fault | Check fan blade for obstruction; replace fan motor |
| E8 | AC current protection / overload | Check power supply; may indicate compressor fault |
| F1 | Outdoor coil temperature sensor fault | Inspect and replace outdoor coil sensor |
| F2 | Discharge temperature sensor fault | Replace discharge temperature sensor |
| H3 | Outdoor high temperature protection | Ensure outdoor unit has shade and clear airflow |
Top Blue Star AC Error Codes Explained in Detail
E4 — High Pressure Protection
Blue Star E4 activates when the system refrigerant pressure is too high. Blocked condenser fins on the outdoor unit are the most frequent cause, particularly in dusty Indian cities. Turn the AC off, clean the outdoor unit’s aluminium fins with a soft brush, ensure at least 60 cm of clearance around the unit, and try restarting. If E4 recurs, a technician should check the refrigerant charge.
E5 — Low Pressure / Refrigerant Fault
E5 typically means the refrigerant charge is low due to a leak. Signs include the AC running but not cooling effectively, and ice forming on the indoor pipe. Do not run the unit — call a Blue Star service technician (1860-425-2525) to diagnose and repair the leak before adding gas.
E6 — Communication Error
If the indoor unit cannot talk to the outdoor unit, E6 appears. After a power surge or outage, this can be a temporary glitch — a 3-minute power cycle at the breaker often resolves it. If E6 persists, the signal wiring between units needs inspection, or the PCB of one unit may have failed.
E7 — Indoor Fan Motor Fault
E7 means the indoor unit’s fan motor has stopped or is running below its rated speed. Check whether anything is obstructing the fan blade through the return air grille. If nothing is blocking it, the motor bearing may have failed and needs replacement.
How to Reset a Blue Star AC After an Error
- Switch off the AC with the remote or wall switch.
- Turn off the AC circuit breaker or MCB.
- Wait 2–3 minutes.
- Restore power and switch the unit on.
- If the code reappears, contact Blue Star service at 1860-425-2525.
When to Call a Technician
- E5 low-pressure error — refrigerant leak diagnosis required.
- E8 overload that keeps returning — possible compressor issue.
- E6 communication error that persists after reset.
- Any fault code that comes back within minutes of restarting.
Related: Sell Your Old AC in Bangalore | Sell Your Old AC in Delhi